lucaaa
Guest
Bye to all,
I have a question for you. I wanted to simulate the performance of particles within a fluid bed reactor (so show the moving particles). knowing that in fluent there is the injection command where you can set different conditions, I wanted to ask you whether it was right to use this command for my simulation or not. Do you have any guidance or ideas?? Because I don't understand much.
Thank you in advance.
Hi.
Luca:smile:
I have a question for you. I wanted to simulate the performance of particles within a fluid bed reactor (so show the moving particles). knowing that in fluent there is the injection command where you can set different conditions, I wanted to ask you whether it was right to use this command for my simulation or not. Do you have any guidance or ideas?? Because I don't understand much.
Thank you in advance.
Hi.
Luca:smile: