sludge roughing

[mary1987]

Hello, everyone!
I have difficulty with creating a simple plot railing.despite I set offsets to 0, it always remains disassembled between mounts and currentsI would like to center currents and mounts but the result is always equal.

Can anyone help me?
What could be the problem?

Thank you very much in advance...

 

[Tristan]

the problem in this case is revit. very small distances (here we are in the order of the millimeter) are not handled correctly. If you want a advice avoid doing the pharmacist, so when you print even at large scales that imperfection is covered by the thickness of the lines and falls within the error of graphicism.
remember; revit is a bim authoring software, not born for blacksmiths, to design railings

 

[mary1987]

Thank you. @tristan I thought I was wrong. .
Yes yes I know that in the printing phase everything is "hidden", but it was for scruple and to improve the familiarity of the sw.
Thank you again!