Andreasox
Guest
Good evening to all, my name is gorea and I am new to the forum:smile:
I've been designing for some time with sw (mostly lost in time), and I would like to ask you a facial information that, in the old discussions, I found nothing about it. . !
yesterday I was commissioned a little particular piece to do, and my difficulty lies in drawing those curved and cut lines, as it was a sweep. drawing is almost like this here attached
http://fc02.deviantart.net/fs41/f/2009/031/3/b/tobi_mask_by_weirdman1992.jpgI thought I'd use a mold to get it all out of me, because I don't know how to get the sketch in the solid's faces and then cut it like that.
I don't know if I've been wrong somewhere, I hope that the debate is not trivial and... I'll call all those who will answer me:
I've been designing for some time with sw (mostly lost in time), and I would like to ask you a facial information that, in the old discussions, I found nothing about it. . !
yesterday I was commissioned a little particular piece to do, and my difficulty lies in drawing those curved and cut lines, as it was a sweep. drawing is almost like this here attached
http://fc02.deviantart.net/fs41/f/2009/031/3/b/tobi_mask_by_weirdman1992.jpgI thought I'd use a mold to get it all out of me, because I don't know how to get the sketch in the solid's faces and then cut it like that.
I don't know if I've been wrong somewhere, I hope that the debate is not trivial and... I'll call all those who will answer me: