standard but orthogonal views

[Bryan]

Good morning, everyone.
after several researches I do not find a complete answer, the doubt is this: I open a file,
at the top select one of the views, we admit the front, now I would like to see with that active view (the frontal note) the object in question but rotated (only visually in sight therefore not doing wheel component) 90°,
I explain, for example, this is the front view of the object " | "and I always front but would like to see it like this " - "
Is it possible to do that? I hope I explained to you to understand my doubt. thanks to all and good work.

 

[MassiVonWeizen]

i.e. you would like to use the front view and without changing any parameter represent the rotated object of 90°?

 

[Bryan]

good morning and thanks for the availability in the meantime, then it is accurate and I try to make an example: Imagine having a mobile phone in your hand with the screen facing you, then the front screen, the side of the short edge down and the long side on the hips. This is your front view. Now I would like, always with the same front view so always having the front screen, rotate it by 90° so to have the long side down and the short side on the sides. technically they are still in the front view, but precisely I'm displaying the object turned 90° to as I had before; Here I would like to do the same with sw views, and I don't understand if you can and how to do it.
Thanks again for the patience.

 

[MassiVonWeizen]

If you want to be more explicit a drawing would be better than a description, and in fact I asked you a very precise question that I repeat:
do you want to see the object rotated but without changing any view parameters or in other words do you want the object to be rotated by 90° at the front view?
and I add, what it means

(only visually in view so not doing wheel component)

you will understand that according to how you want to achieve a certain thing there are certain more or less complex solutions

 

[MassiVonWeizen]

or are you looking for a simple wheel view

 

[Bryan]

I did a lot of tests with your suggestion, I really wanted to get this

see the rotated object but without changing any parameter of the view

and as you told me I tried to use the scorri command seen, after putting in front view, does exactly what I was looking for, only thing, I can not make it rotate by 90° exact, but I found a way to do it in two steps: after clicking on You see, place the object near 90° then click "normal a" and you position exactly orthogonally at how it was before, great!
Thank you very much for your help!

 

[MassiVonWeizen]

it is easier to enter the model, set the position and in the drawing select from the various views "current model view"

 

[re_solidworks]

There is also another possibility, which I use a lot when I get models made by others with the origin of the axes in a creative position. position the model exactly as you want it to be your front view, press the space bar and click the third telescope icon at the top, the command is called "update standard views". then click on the icons under the front view and the question "if you change.... blah blah..." I answer yes.
then go to the table and you will find the views as you want.

 

[Bryan]

very interesting, thank you, I tried both systems and both the method of mass and yours to do Aggiorna saw him have been resolute, I'll keep them both in mind. Thanks again for everything!