topsolid - adactivity

[Markino]

Hello everyone.. .

I designed a rectangular piece and inside I created them a socket; inside this asola passes a pin.

Now, the pin moves back and forth but I want that when it comes to touch the end of the asola, the rectangle moves in the same direction as the pin, it becomes adaptive.
I hope I've been clear.


I thank in advance anyone who answers my "problem":finger::finger:

 

[Stefano Vezzani]

hi markino, you have to create a system of constraints and then associate two stop reports on the two estermitas of the asola fittings.
If you don't understand, let me know I'll make you a movie.

Hi.

 

[Markino]

Hello stefano! !

Thank you for responding.
I prefer the second option (the one of the film) because so written I get a little difficult.

Good day

 

[Markino]

Help! ! ! !
someone willing to film me on this example? or even a step by step all obviously written (according to me a break of squares)

Thanks again you have willing that they will prepare has given me an answer! ! ! !

 

[Markino]

Hey, guys!
Thanks to go! !
the problem was partly solved! ! ! !


i.e., the problem of the asola does not come out but what I asked was only because in an assembly I had done, I had to apply this problem with a small variant, I had not to lean a tree at a radius but rather 1 plan against the other! !

andrea told me to press f1 and type the command "stops" (help in English),
Here, it shows you a small film that explains everything.

Therefore, I thank you very much andrea that has helped me to solve the problem (of course the one reported to the asola hihih is still open!).
to the prox!!!!!!:finger::finger: