Angelo_leo
Guest
Good morning, guys.
Here I am asking for help.
I have the need to have a dynamic block of a stretched sheet, classic block with two parameters in h: plate height and l:sheet width, connected to two attributes with the field visible in print.
I would like to add a third attribute that should be the label of the sheet that will be different from one other only for h or l. the latter attribute must be updated automatically with a progressive number when I go to change one of the parameters mentioned above
an example
sheet 1 = l:1000 h:800 m:m1 (m=parameter can be automatically updated to vary l or h)
sheet 2 = l:1250 h: 800 m:m2 (m= automatic change to dl l)
sheet 3 = l:1250 h: 650 m:m2 (m= automatic change to dl h)
What do you think, do you think that's feasible?
because at the moment I vari h and l that autornano to every rescue, but the parameter I go to change by hand, and I happen very often to reassign the same brand to a different sheet.
Here I am asking for help.
I have the need to have a dynamic block of a stretched sheet, classic block with two parameters in h: plate height and l:sheet width, connected to two attributes with the field visible in print.
I would like to add a third attribute that should be the label of the sheet that will be different from one other only for h or l. the latter attribute must be updated automatically with a progressive number when I go to change one of the parameters mentioned above
an example
sheet 1 = l:1000 h:800 m:m1 (m=parameter can be automatically updated to vary l or h)
sheet 2 = l:1250 h: 800 m:m2 (m= automatic change to dl l)
sheet 3 = l:1250 h: 650 m:m2 (m= automatic change to dl h)
What do you think, do you think that's feasible?
because at the moment I vari h and l that autornano to every rescue, but the parameter I go to change by hand, and I happen very often to reassign the same brand to a different sheet.