solidworks incremental numbers extrusion

[Abe77]

Good morning,

has been trying for days to create a circular extrusion surface on which to extrude in turn wrapped numbers: what
I would like, in practice, to decide the number of extrusions to be represented and to make the first extrusion have number 1, the last extrusion
have the number I have decided, es 40: I have operated through equations to set the diameter of the extrusion surface and I have tied the text
to a line whose length is the development of the extrusion surface; In this way, however, I must write the sequence of numbers by hand and the wrapping of numbers does not come to the bottom, I do not know why, as I do not know why when the text becomes 2 digits (e.g. number 10 rather than number 1, the 2 digits are particularly distant from each other)
with the circular repeat command, instead, I cannot create an incremental function with the extruded text linked to a variable of the functions,
Does anyone know how to do it?
Thank you all in advance,
Thank you.
Tree.

 

[MassiVonWeizen]

Maybe you can do it through data table.as written in the guide the text can be connected to properties and then to a data table.

 

[MassiVonWeizen]

I did some evidence and I didn't come out alive.
thinking about it above I think it is very difficult because to make the number you need a text sketch and this is not insertable if not manually (the data table modifies existing elements but can neither create nor delete them). you can't even use repetition in the sketch because you don't recognize the text as an entity.
If there is a way in my opinion it is only through macro that allows to create actions instead of just changing them.

 

[Abe77]

I did some evidence and I didn't come out alive.
thinking about it above I think it is very difficult because to make the number you need a text sketch and this is not insertable if not manually (the data table modifies existing elements but can neither create nor delete them). you can't even use repetition in the sketch because you don't recognize the text as an entity.
If there is a way in my opinion it is only through macro that allows to create actions instead of just changing them.

I thank you, I smelled it was complicated for the macros I can't do, so for the moment it stays in stand-by, with the configurations
It would take at least 40...!