problem thickness lines

[fidippide]

good morning to all, useful catia v5 r19 and I always found a problem in the drafting environment. in particular some lines are more thick than others (see attached image). How can I do that? Thank you very much.

 

[Giogo]

hi, the problem is not the thickness of the lines, but the sampling of the section, the areas you see "evidenced"
with bigger thickness, they are those where the sampling is not represented because of the step, try to put a smaller value of the dash.

 

[fidippide]

nice yoke, thank you for your answer. if I activate the current selection and right click on properties, I open the window you highlighted but without the curtain "tracting". How come? Thank you very much!

 

[fidippide]

Dear yoke, I right clicked on the section sampling and decreased the step: it worked. My menu is slightly different: I have the "martress" tendon instead of "trate". The problem is that there are sectional areas that do not even have a sampling line and I do not know how to change the pitch. Thank you very much!

 

[mcbramby]

click on the rows holding "alt" and then choose hold ........... .

 

[mcbramby]

then obviously change/property

 

[fidippide]

Thanks mcbramby but there are parts section of components that do not have any sampling and I can therefore click on anything.

 

[mcbramby]

the alt key with the selection you can use it everywhere.................. is very comfortable in the assemblies x take an internal piece

 

[mcbramby]

So the thickness of the most marked line is not a sampling??? ? ?

 

[fidippide]

in the figure there are 4 dice; in 3 dice I managed to change the space of the sampling, in one no (third from above), because there is no sampling, unfortunately it does not pass.

 

[fidippide]

no, the greater thickness highlights the contours of a piece in which the sampling is not well "developed".

 

[mcbramby]

if you go to the marked row with crushed alt and click with the mouse sx ......... Don't give you at least two selections... one of which is the sampling?? ?

 

[fidippide]

I managed mcbramby! I don't know what I did but I managed to select the sampling even where it wasn't there. thanks! but the "alt" key precisely what does it do? I feel very powerful. Sorry to take advantage of your kindness.

 

[mcbramby]

I wrote it above.... .
the alt key with the selection you can use it everywhere.................. is very comfortable in the assemblies x take an internal piece, practically you select everything that is superimposed ....... and you select its selections what to select......... prove it is very useful

 

[mcbramby]

for kindness then....... It is a pleasure

 

[fidippide]

Try! Thank you!